
Bench Press Pyramid: Percentages and Chart | Combat Fitness
Bench Press Pyramid: How to Run It (and When Reverse Is Better)
A bench press pyramid is a set scheme where each set climbs in weight and drops in reps until you reach a heavy top set. You can also run it in reverse and start heavy. A simple version off a 225-pound max looks like this: 10 reps at 145, 8 at 155, 6 at 165, 4 at 180, and 2 at 190. We use pyramids inside our tactical fitness programs as one tool for driving a bench max toward a test date. They are a tool, not the whole plan.
Below you’ll get the exact percentages, how to pick your top set, the honest case for the reverse pyramid, a sample chart by max, and the situations where straight sets beat both. Start with the method.
How Do You Run a Bench Press Pyramid?
A bench press pyramid workout runs four to six working sets off your one-rep max (1RM). Each set adds load and cuts reps, so you warm into a heavy top set while building volume on the way up. The standard ascending pyramid climbs from about 65 to 85 percent of your max.
Bench press pyramid percentages
Set 1: 10 reps at 65 percent
Set 2: 8 reps at 70 percent
Set 3: 6 reps at 75 percent
Set 4: 4 reps at 80 percent
Set 5: 2 reps at 85 percent
These numbers are deliberate. Based on the standard percentage-to-rep relationship published by the NSCA, most lifters can get about 10 reps at 75 percent and about 6 at 85 percent. Every set above stops roughly four reps short of failure. That keeps fatigue low enough for your top set to move at full speed, and it gives you a built-in readiness check: if the 75 percent set feels like a grinder, the day is not a PR day. The range also matches the 65 to 85 percent loading used in a 2024 bench press study of trained men.
The exact rep spread matters less than lifters assume. In one trial, a narrow 12/10/8 pyramid and a wide 15/10/5 pyramid produced similar strength gains. Pick a structure you can repeat and progress.
Rest, frequency, and how to progress the routine
Rest two to three minutes between the heavier sets, in line with ACSM guidance for multi-joint strength work. Run the pyramid once a week as your heavy bench day, and keep a second, lighter press day if your schedule allows.
Progress by adding 5 pounds to the top two sets once every rep moves cleanly, or by raising the whole pyramid 2.5 percent the following week. Run a block of four to six weeks, then retest. Many coaches calculate from a training max of about 90 percent of a true max, a convention popularized by Jim Wendler. Starting conservative is the right call when you’re also rucking and running, because your recovery is shared across all of it. The pyramid also needs a home inside a complete week, and our guide to choosing a strength & endurance program lays out what that week should include.
Ascending vs. Reverse Pyramid: Which Builds More Strength?
A reverse pyramid puts your heaviest set first, while you’re fresh, then drops the weight about 10 percent and adds reps each set. For pure 1RM strength, reverse usually makes more sense. An ascending pyramid suits volume and hypertrophy because the lighter sets accumulate work before the top set.
The reasoning comes down to load. A meta-analysis by Schoenfeld and colleagues found that maximal strength gains favor heavy loads, while muscle growth occurs across a wide spectrum of loads. In an ascending pyramid, your heaviest set comes after 28 reps of accumulated fatigue. In a reverse pyramid, you hit it first with full bar speed, so the set that drives strength gets your best effort. For size, total hard sets matter most, and research shows a graded dose-response between weekly volume and muscle growth. Ascending pyramids deliver that volume efficiently.
Sample reverse pyramid bench press (225-pound max)
Warm up in light sets of 5, 3, and 1, climbing to about 75 percent
Set 1: 5 reps at 85 percent (190 pounds)
Set 2: 7 reps at 77.5 percent (170 pounds)
Set 3: 9 reps at 70 percent (155 pounds)
Don’t skip the warm-up in a reverse pyramid. Thomas DeLorme’s original ascending scheme from the 1940s treated its lighter sets as preparation for one heavy set, and that logic still applies when you put the heavy set first.
The acute data show no clear winner. In the 2024 bench study, ascending, descending, and constant-load sessions were all viable, though the descending order produced lower peak bar speed. A full pyramid that climbs up and then back down costs the most fatigue. Use it occasionally for volume, never in the weeks before a test.
Bench Press Pyramid Chart: Sample Weights by Max
A bench press pyramid chart lists your working weight for each set as a percentage of your max. Multiply your 1RM by 0.65, 0.70, 0.75, 0.80, and 0.85, then round down to the nearest 5 pounds. Below are ascending pyramid weights for five common maxes.
Sample pyramid weights (10/8/6/4/2 reps)
135-pound max: 85, 90, 100, 105, 110
185-pound max: 120, 125, 135, 145, 155
225-pound max: 145, 155, 165, 180, 190
275-pound max: 175, 190, 205, 220, 230
315-pound max: 200, 220, 235, 250, 265
How to calculate your pyramid weights from your max
Use a tested 1RM from the last six to eight weeks.
No recent max? Estimate one with the Epley formula: weight × (1 + reps ÷ 30). A set of 185 for 5 estimates to about 215. Estimates are most accurate from sets of 10 reps or fewer.
Multiply by 0.90 if you want a conservative training max.
Multiply that number by each set’s percentage and round down.
Named routines that circulate online, such as the Nebraska pyramid or the six-pack smackdown, run through the same math. Before you follow one, check three things: the top percentage, the total reps, and how many reps each set leaves in reserve. Coaches commonly gauge that last number with a reps-in-reserve scale.
Set Up the Press Before You Load the Pyramid
A pyramid adds load every set, so any flaw in your setup gets more expensive as the bar gets heavier. Lock in proper bench press form before you chase percentages. If your bar path drifts on the 80 percent set, the 85 percent set stops being strength work and becomes a technique failure under load.
Is the Bench Press Pyramid Good for Strength? Who It Suits and Its Limits
The bench press pyramid is a good way to build strength when you need a simple, self-regulating structure to drive a bench max over a four- to eight-week block. It is not superior to straight sets. Controlled trials comparing pyramid and constant-load systems found similar gains in strength and muscle.
In a randomized crossover trial, chest press 1RM rose 12.4 percent on a traditional constant-load program and 11.5 percent on a pyramid, with no meaningful difference between them. A follow-up in trained participants reached the same conclusion: both work, and the pyramid is not better. Both studies used older women, so treat them as directional, not definitive, for tactical athletes.
Where the pyramid earns its place:
It builds a warm-up into the working sets.
It flags a bad day early, before you load the top set.
It combines volume and intensity in one exercise.
Where straight sets or a percentage plan beat it:
In the final weeks before a test, when you need fewer, heavier sets.
On short sessions, when five climbing sets eat the clock.
When bench is one of several main lifts and needs precise dosing.
For a tactical athlete, a stronger bench matters, but it can’t come at the expense of pulling strength or your shoulders. Pair every pyramid with rows or pull-ups and a lower-body lift, the way we lay out a strength workout for athletes. The bench is one lift inside functional strength for military performance, not the measure of it.
Frequently Asked Questions
What is a bench press pyramid?
A bench press pyramid is a set structure where load rises and reps fall across consecutive sets, ending at a heavy top set. A reverse pyramid flips the order, starting with the heaviest set and getting lighter. Both are ways to organize volume and intensity for one lift in a single session.
What percentages should a bench pyramid use?
A standard ascending bench pyramid uses 65, 70, 75, 80, and 85 percent of your 1RM for 10, 8, 6, 4, and 2 reps. That leaves about four reps in reserve on every set. A reverse pyramid typically starts at 85 percent and drops about 10 percent per set while adding two reps.
Ascending vs. reverse pyramid: which is better for strength?
The reverse pyramid is usually better for maximal strength because you perform the heaviest set fresh, with full bar speed. The ascending pyramid suits volume and muscle growth. Research comparing the two acutely found both viable, so choose by goal: reverse in the weeks before a test, ascending in a building phase.
How do you calculate your pyramid weights from your max?
Multiply your 1RM by each set’s percentage and round down to the nearest 5 pounds. If you don’t have a recent max, estimate it from a set of 10 reps or fewer using the Epley formula: weight × (1 + reps ÷ 30). Using 90 percent of that number as a training max keeps the early weeks manageable.
Pyramid sets vs. straight sets: when should you use each?
Use pyramid sets when you want a built-in warm-up and a mix of volume and heavy work in one lift. Use straight sets when you’re peaking for a test, training on a tight clock, or managing several main lifts that need precise dosing. Both build strength when progressed.
The bench press pyramid is a straightforward, self-regulating way to push your bench max, as long as you treat it as one scheme rather than a secret. Build volume with the ascending 10/8/6/4/2 off a conservative max, switch to a reverse pyramid in the four weeks before your test, and keep rows and pull-ups in every session. If you want that balance built for you, start a CF ONE free trial and train a plan where the bench, the ruck, and the run all progress together.
References:
Mang ZA, Beam JR, Vigil ED, Martinez AH. The Acute Effect of Ascending-Pyramid, Descending-Pyramid, and Constant-Load Set Configurations on Repetition Performance, Training Volume, and Barbell Velocity During Bench Press Exercise. International Journal of Strength and Conditioning. 2024;4(1).
Ribeiro AS, Schoenfeld BJ, Fleck SJ, et al. Effects of Traditional and Pyramidal Resistance Training Systems on Muscular Strength, Muscle Mass, and Hormonal Responses in Older Women: A Randomized Crossover Trial. J Strength Cond Res. 2017;31(7):1888-1896.
Ribeiro AS, Aguiar AF, Schoenfeld BJ, et al. Effects of Different Resistance Training Systems on Muscular Strength and Hypertrophy in Resistance-Trained Older Women. J Strength Cond Res. 2018;32(2):545-553.
dos Santos L, Ribeiro AS, Cavalcante EF, et al. Effects of Modified Pyramid System on Muscular Strength and Hypertrophy in Older Women. Int J Sports Med. 2018;39(8):613-618.
Schoenfeld BJ, Grgic J, Ogborn D, Krieger JW. Strength and Hypertrophy Adaptations Between Low- vs. High-Load Resistance Training: A Systematic Review and Meta-analysis. J Strength Cond Res. 2017;31(12):3508-3523.
Schoenfeld BJ, Ogborn D, Krieger JW. Dose-Response Relationship Between Weekly Resistance Training Volume and Increases in Muscle Mass: A Systematic Review and Meta-analysis. J Sports Sci. 2017;35(11):1073-1082.
Swinton PA, Schoenfeld BJ, Murphy A. Dose-Response Modelling of Resistance Exercise Across Outcome Domains in Strength and Conditioning: A Meta-analysis. Sports Med. 2024;54(6):1579-1594.
American College of Sports Medicine. Progression Models in Resistance Training for Healthy Adults (Position Stand). Med Sci Sports Exerc. 2009;41(3):687-708.
Haff GG, Triplett NT, eds. Essentials of Strength Training and Conditioning. 4th ed. National Strength and Conditioning Association. Human Kinetics; 2016.
DeLorme TL. Restoration of Muscle Power by Heavy-Resistance Exercises. J Bone Joint Surg. 1945;27(4):645-667.
Epley B. Poundage Chart. Boyd Epley Workout. Lincoln, NE; 1985.
Reynolds JM, Gordon TJ, Robergs RA. Prediction of One Repetition Maximum Strength From Multiple Repetition Maximum Testing and Anthropometry. J Strength Cond Res. 2006;20(3):584-592.
Helms ER, Cronin J, Storey A, Zourdos MC. Application of the Repetitions in Reserve-Based Rating of Perceived Exertion Scale for Resistance Training. Strength Cond J. 2016;38(4):42-49.
Wendler J. 5/3/1: The Simplest and Most Effective Training System for Raw Strength. 2nd ed. 2011.
Disclaimer: This article is for educational purposes and is not medical advice. Consult a qualified healthcare provider before starting a new training program, especially if you have a shoulder, elbow, or chest injury. Always bench with a spotter or safety arms when working near your max. Individual results vary.

